Troubleshooting
Mirage M Series User Manual
121
020-101942-02 Rev. 1 (10-2018)
IP address is likely in conflict with another address already in use. Contact your network
administrator.
2. Ensure Ethernet settings are valid for the site. All devices should have the same subnet mask
yet unique IP addresses.
Display
Learn more about resolving common display-related issues.
The projector is on but there is no display
1. Was a lens cover accidently left on? Remove the lens cover.
2. On the LCD display, check that the shutter is open. This is also indicated by the shutter LED
being green.
3. Is the correct input selected? Check the cable connections.
4. Check if menus appear on the screen.
5. Can you access test pattern? Ensure a full black test pattern has not been selected for display,
press
Menu
to access test patterns, then cycle patterns with keys. Check your source
connections again.
Severe motion artifacts
1. Most likely a synchronization problem has occurred with reversed 3-2 pull-down in 60Hz-to-
24Hz film-to-digital conversion in your source. Correct at the source.
2. Set the projector to run in Free run. Open the
OSD
menu and go to
Input Switching
and
PIP
.
Ensure Running mode is set to
Free Run
not to
Frame Lock
.
3. Display a test pattern on the screen, pressing
Test
on the remote keypad. The test pattern
should be displayed correctly. If not, contact your dealer for assistance.
Image appears squeezed or vertically stretched into center of
screen
1. To run auto setup, press
Auto
on the remote keypad.
2. Check your resizing selection.
The display is jittery or unstable
1. If the display is jittery or blinking erratically, ensure the source is properly connected and of
adequate quality for detection. With a poor quality or improperly connected source, the
projector repeatedly attempts to display an image, however briefly.
http://www.pureglare.com.au
