Additional hazard labels
Light intensity hazard distance
This projector has been classified as Risk Group 2 as per the
IEC62471(2006) (First Edition) standard due to possible hazards
optical radiation being emitted.
When the screen is removed, directly viewing the beam with an
optical instrument (for example, an eye loop, magnifier or
microscope) from a distance of less than 220mm may pose an eye
hazard. MicroTiles is a Risk Group 2 source of visible LED radiation.
Important safeguards
To prevent personal injury and to protect the device from damage, read and follow these safety
precautions.
General safety precautions
Observe these important safety rules to avoid personal injury or damage to the product.
Warning! If not avoided, the following could result in death or serious injury.
•
TIP HAZARD! Any array two rows or higher, mounted to the leveling feet, must be fastened to an
adequately ballasted base structure to provide stability and prevent tipping.
Caution! If not avoided, the following could result in minor or moderate injury.
•
Always provide proper ventilation for the product to prevent overheating.
•
Christie products must be installed and serviced by Christie qualified technicians.
Notice. If not avoided, the following could result in property damage.
•
Always handle the screen from its sides. Do not touch the inside of the screen.
•
Remove all jewelry before handling the screen.
•
Do not over-tighten hardware.
•
Do not use power tools to install the hardware.
•
Excessive force or repeated screen removal may damage the screen.
•
Do not place the screen on a hard surface.
•
Do not set the screen on its corner or edge.
•
Always wear clean, lint-free gloves when handling the product.
•
Only use cleaning solutions recommended by Christie. All other cleaning solutions may cause
product damage and will void the warranty.
•
Only use compressed air with the appropriate guarding and protective equipment.
•
FIRE AND SHOCK HAZARD! Use only the attachments, accessories, tools, and replacement parts
specified by Christie.
•
The intake air must be clean and be clear of dirt and dust. Failure to ensure a clean air supply
may void the warranty.
•
Always provide proper ventilation for the product to prevent overheating.
Product overview
Christie MicroTiles Installation and Setup Guide
8
020-100329-15 Rev. 1 (05-2018)
Copyright
©
2018 Christie Digital Systems USA, Inc. All rights reserved.
