1. Ensure the surface of the screen removal tool is clean and free of debris to avoid damaging the
screen.
2. Open the handle on the screen removal tool and gently place it in the center of the screen.
3. Carefully, push the screen removal tool towards the screen using moderate pressure (no more
than 5 lbs / 2.27 kg).
4. Close the handle on the screen removal tool to apply suction.
5. To remove the screen, carefully pull on the screen removal tool.
Connecting the cables between the ECUs and MicroTiles
Connect the cables row by row when an array is set up near a wall. When setting up an array where
the back is exposed, first set up the entire array and then connect the cables.
Ensure there is sufficient slack in the cable to allow servicing of the tile from the front. Do not tie wrap
or secure the cabling if the array is set up near a wall.
1. Plug the display port cables into either of the two ports on the back of the tiles.
Either port is acceptable on both the ECU and the tile unless connecting multiple ECUs. When
using multiple ECUs, HSSL-1 is the local source input and HSSL-2 is the local source output.
2. Daisy chain the cable from one tile to the next and plug the last one back into the ECU.
It is not necessary to make a complete loop; however, communication to the entire array will
not be lost if one tile fails.
3. To remove the cable, press down on the cable tab.
Cooling the array
Tiles are cooled only from the back, and if the array is installed in an enclosed area, additional cooling
may be required in order to comply with safety regulations and local codes.
Notice. If not avoided, the following could result in property damage.
•
The intake air must be clean and be clear of dirt and dust. Failure to ensure a clean air supply
may void the warranty.
•
Always provide proper ventilation for the product to prevent overheating.
Installation and Setup
Christie MicroTiles Installation and Setup Guide
25
020-100329-15 Rev. 1 (05-2018)
Copyright
©
2018 Christie Digital Systems USA, Inc. All rights reserved.
