57
Configuring communications
•
Reset to Default
—Resets the network configuration setting, including LAN setting and
WLAN setting, to default.
3. To apply the network configuration, press
ENTER
.
Setting serial port baud rate
Select the serial port and baud rate.
1. Select
Menu
>
Configuration
>
Communications
>
Serial Port Baud rate
.
2. Set up the appropriate baud rate.
3. To confirm the selection, press
ENTER
.
Enabling serial port echo
Enable or disable to allow the CLI command pass through.
1. Select
Menu
>
Configuration
>
Communications
>
Serial Port Echo
.
2. To swap, press
ENTER
.
Setting the projector address
Assign an address to the projector for IR remote connection.
1. To set the projector address, select
Menu
>
Configuration
>
Communications
>
Projector
Address
.
2. Select specific number for this projector from 0 to 9. The projector responds to the IR remote
set to the same address as the projector or to the IR remote set to address 0.
3. To match up with the projector address, press
PROJ
and specific number key.
Adjusting the back light settings
Control the back light behavior and timeout setting for the keypad and status LED.
1. Select
Menu
>
Configuration
>
Backlight Preferences
>
Keypad Backlight
.
2. Select the appropriate setting for keypad backlight.
3. To confirm the selection, press
ENTER
.
4. Select
Menu
>
Configuration
>
Backlight Preferences
>
Status LED
.
5. Select the appropriate setting for status LED.
6. To confirm the selection, press
ENTER
.
GS Series 2K User Manual - DWU880-GS, DWU880A-GS, DWU9200-GS, DWU1100-GS, DWU1100A-GS
020-001908-01 Rev. 1 (
02
-202
2
)
Copyright © 202
2
Christie Digital Systems USA Inc. All rights reserved.
