37
Adjusting the image settings
Inverting 3D signal
3D images consist of a series of images (frames) that alternate quickly between two slightly
different view points, corresponding to our left and right eyes. When these frames are displayed
fast enough and viewed with 3D glasses synchronized to the left/right (L/R) changes, the resulting
image appears with the same depth and perspective that is sensed in the real world.
If the projector generates the sync internally and content is displayed without 3D sync in the cable
connected to the projector, the content has a 50% chance of being displayed with the left/right eyes
swapped. This function is used for swapping the sequence of the image to make the resulting image
appear normally.
1. Select
Menu
>
Image Settings
>
3D Display
>
3D Invert
.
2. To swap, press
ENTER
.
Selecting the 3D sync input signal
This function is used for selecting the 3D sync input option.
1. Select
Menu
>
Image Settings
>
3D Display
>
3D Sync In Select
.
2. Select the appropriate 3D sync in setting.
•
Auto
—If an external 3D sync input is detected, the projector uses automatically the external
sync input. If no external sync input is detected, the projector uses the internal 3D sync to
display the content.
•
Internal
—The projector generates the 3D sync internally and content is displayed.
•
External
—The projector uses an external 3D sync input to display the content.
3. To confirm the selection, press
ENTER
.
Setting the 3D sync output signal
This function is used for controlling and processing the 3D sync output signal.
1. Select
Menu
>
Image Settings
>
3D Display
>
3D Sync Out
.
2. Select the appropriate 3D sync out setting.
•
To Emitter
—If the 3D sync out port is connected to an emitter, select
To Emitter
to
transmit 3D signal to emitter and give to 3D glasses.
•
To Next Projector
—Multiple projectors 3D application only. Select
To Next Projector
when the 3D sync out port is not connected to an emitter.
3. To confirm the selection, press
ENTER
.
For multi-threaded applications, if the 3D enable function is set to Frame Sequential, Christie
recommends to connect the source device to the projector via 3D Sync In port. The Frame Delay
function will ensure a synchronized display for multiple projectors.
GS Series 2K User Manual - DWU880-GS, DWU880A-GS, DWU9200-GS, DWU1100-GS, DWU1100A-GS
020-001908-01 Rev. 1 (
02
-202
2
)
Copyright © 202
2
Christie Digital Systems USA Inc. All rights reserved.