Warning! If not avoided, the following could result in death or serious injury.
•
This product must be operated in an environment that meets the operating range as specified in
this document.
•
Do not look directly into the lens when the light source is on. The extremely high brightness can
cause permanent eye damage.
•
EXTREME BRIGHTNESS! When accessing a restricted access location for product service or
maintenance, avoid exposure to the product beam path by turning the product power off and
disconnecting the product from AC power, or by shuttering the light source to avoid emissions
from the front aperture.
•
FIRE HAZARD! Keep hands, clothes, and all combustible material away from the concentrated
light beam of the projector.
•
Keep fingers and other body parts away from the moving parts in the product. Tie back long
hair, and remove jewelry and loose clothing before manually adjusting the product.
•
FIRE AND SHOCK HAZARD! Use only the attachments, accessories, tools, and replacement parts
specified by Christie.
•
Do not operate the product without a lens installed.
•
Always use a lens plug when installing or moving the product. This prevents contaminants from
entering the product.
•
FIRE AND SHOCK HAZARD! Use only the attachments, accessories, tools, and replacement parts
specified by Christie.
Caution! If not avoided, the following could result in minor or moderate injury.
•
TRIP OR FIRE HAZARD! Position all cables where they cannot contact hot surfaces, be pulled, be
tripped over, or damaged by persons walking on or objects rolling over the cables.
Installation safety and warning guidelines
Read all safety and warning guidelines before installing the projector.
Warning! If not avoided, the following could result in death or serious injury.
•
Possible hazardous optical radiation emitted from this product. (Risk group 3)
•
High leakage current present when connected to IT power systems.
•
Christie products must be installed and serviced by Christie qualified technicians.
•
Do not operate the product without all of its covers in place.
•
A minimum of four people or appropriately rated lift equipment is required to safely lift, install,
or move the product.
•
Always install safety straps when the frame and projector are installed overhead.
•
Observe load ratings and applicable local safety codes.
•
When installing the projector in portrait mode, the rigging device must have a sufficient load
rating, as identified in this manual.
•
This product must be installed within a restricted access location not accessible by the general
public.
•
Install the product so users and the audience cannot enter the restricted area at eye level.
•
Only personnel who are trained on the precautions for the restricted access location can be
granted entry to the area.
•
Only Christie qualified technicians are permitted to open product enclosures.
Introduction
4K40-RGB Installation and Setup Guide–D4K40-RGB, Roadie 4K40-RGB
7
020-102961-03 Rev. 1 (08-2019)
Copyright
©
2019 Christie Digital Systems USA, Inc. All rights reserved.
