Christie D4K25, Service Manual

Page: 79 / 138

Section 5: Parts and Module Replacement
D4K25 Service Manual 5-27
020-100880-01 Rev. 1 (06-2012)
5.11.6 Low Voltage Power Supply (LVPS)
(Estimated Replacement Time: 30 minutes)
The LVPS is mounted behind the LVPS/LPS cover to a vertical plate near the LPS. It powers the entire
projector except for the TPC.
1. Remove the LVPS/LPS cover. See
5.4.8 LVPS/LPS Cover, on page 5-8.
2. Disconnect LVPS harness inline connections from AC relay.
3. Disconnect all inline connections to the LVPS (harnesses stay with the LVPS).
4. Using a 3mm hex key, remove the four socket head screws securing the LVPS to the wall.
5. Remove the two angled brackets from LVPS using a #2 Phillips
™
.
5.12 Lamp Compartment
5.12.1 Anode Yoke
The anode yoke (also known as the lamp anode stand) sits just in front of the lamp reflectors. It is mounted to
the baseplate of the projector and is used to support the anode end of the lamp.
(Estimated Replacement Time: 4 minutes)
1. Open lamp door. See 5.4.7 Lamp Door, on page 5-8.
2. Remove lamp. See 5.12.5 Lamp, on page 5-30 .
3. Remove the two screws (using 5mm hex key) securing the anode yoke to the baseplate ( Figure 5-36 ).
Figure 5-36 Front of Lamp Compartment
(shown with lamp removed)