Installation and setup
HS Series D16-20 Installation and Setup Guide
27
020-001464-02 Rev. 1 (10-2018)
Copyright ©2018 Christie Digital Systems USA Inc. All rights reserved.
Turning on the projector
The projector cables must be securely connected before turning the power on.
1. Plug the projector in to AC power.
The Power button on the built in keypad is illuminated when the power cables are connected.
2. Ensure the lens has been installed in the projector by a Christie qualified service technician.
3. Ensure that no one or no objects are in the beam path before turning on the projector.
4. To turn on the projector, on the IR remote keypad or on the built-in keypad press .
The status LED is green with a long blink.
5. To select an input source and turn it on, on the IR remote keypad select INPUT.
Available input sources are VGA, HDMI1, HDMI2, DVI, 3G-SDI, and HDBaseT.
The projector detects the source you selected and displays the image.
6. If using the projector for the first time, select a preferred language from the Main Menu after
the startup screen is displayed.
Turning off the projector
Power off the projector in preparation for inspection or maintenance.
1. To turn the projector off, on the IR remote keypad or built-in keypad press .
A warning message appears on the displayed image.
2. To confirm your selection, press again.
If you do not press again, the warning message disappears after three seconds and the
projector remains on.
Warning! If not avoided, the following could result in death or serious injury.
• Do not look into the projector lens when the laser is on. The bright light may result in permanent
eye damage.
Warning!
If not avoided, the following could result in death or serious injury.
• Installing or replacing a lens must be done by a Christie qualified service technician to avoid
exposure to dangerous emission levels.
