Service setup
H Series Service Manual
24
020-000802-03 Rev. 1 (12-2016)
Performing a network function test on the
network port
To preform the network function test, complete the following steps.
1. Record the projector IP adress.
a. Plug in power cord to the projector, connect PC and projector by LAN cable.
b. Turn on the projector.
c. On the IR remote keypad, select Menu > Configuration > Communications >
LAN.
d. Make sure DHCP is disabled.
e. Write down the following information:
• The IP address: 192.168.0.100 (default)
• The Subnet Mask: 255.255.255.0 (default)
2. Set the projector IP address in the network settings.
a. On the PC, double-click the Local Area Connection.
b. Click Properties.
c. Select Internet Protocol (TCP/IP).
d. Click Properties.
e. Set the IP Address to 192.168.0.240.
f. Set the Subnet Mask to 255.255.255.0.
The Host ID
(192.168.0.XXX) of the PC IP Address must be different from the
projector IP address.
g. Click OK.
h. Click Close.
3. Read the projector information.
a. Connect the PC and the projector RJ45 Port by LAN cable.
b. Use Internet Explorer to navigate to http://192.168.0.100.
c. Select Administrator for access type.
d. Enter the password admin.
e. Click Login.
i
Internet Explorer version 8 or higher is required.