5-26
CP2230 Service Manual
020-100562-06 Rev. 1 (05-2016)
Section 5: Parts and Module Replacement
5.10.4 Projector Intelligence Board (PIB)
The PIB is located in the cardcage on the operator side (right) of the projector. It is the main controller for the
Serial and Ethernet connections, video and 3D applications for the projector. The Marriage status light on the
PIB board turns OFF when the high security lid is unlocked. To remarry the board, refer to
.
(Estimated Replacement Time: 15 minutes)
1. Remove the front lid. Refer to
2. Remove the high security lid. Refer to
High Security Lid, on page 5-6
.
3. Remove PIB/ICP cover. Refer to
.
4. Remove the security ring from the front of the
cardcage by pressing down on the latch located
on the side of the cardcage. (
Figure 5-32
Remove Security Ring, on page 5-22
)
5. Push in the red tabs on the top and bottom PIB
ejector tabs. Then, push in the top and bottom
black tabs to release the PIB Board from the
Backplane.
6. Pull the PIB assembly out of the cardcage. (
Figure 5-37
)
7. When installing, repeat the above instructions in reverse. Verify the software version installed. For details,
refer to the
CP2230 User Manual (P/N: 020-100430-xx)
. Once the projector is up and running, Service
Marriage must be performed to continue playing encrypted content. Marriage should only be reset by
Christie authorized service technicians. Refer to
3.6 Performing Marriage, on page 3-17
.
Figure 5-37 PIB, PIB Faceplate and LD
