5-10
CP2230 Service Manual
020-100562-06 Rev. 1 (05-2016)
Section 5: Parts and Module Replacement
5.5.10 Access Panel Frame
The Access Panel Frame is located on the operator side (right) near the front of the projector. To access the
components in the cardcage and light engine compartments the access panel frame must first be removed.
(Estimated Replacement Time: 8 minutes)
1. Remove PIB/ICP Cover. (
Figure 5-9
)
2. Remove the light engine air filter cover (including filter).
(
Figure 5-12
)
3. Remove the four, #2 Phillips
™
screws from the top of the
access panel frame securing it to the chassis.
(
Figure 5-10
)
4. Tilt the access panel frame a little to the front (lift left
side) to clear the LVPS/LPS cover and remove.
5.5.11 Rear Top Lid
The rear top lid can be rotated around the exhaust opening. To remove the rear top lid completely the exhaust
must be removed.
(Estimated Replacement Time: 10 minutes)
1. Remove external ducting.
2. Remove the front top lid. Refer to
3. Open the lamp door. Refer to
4. Remove lamp (if installed). Refer to
Lamp Replacement, on page 5-38
5. Remove the rear right skin. Refer to
6. Remove the two screws securing the rear lid to
the chassis. (
Figure 5-11
)
Figure 5-10 Access Panel Frame
Figure 5-11 Rear Lid