Christie CIC 1DLP Camera Installation and Setup Guide
4
020-002066-01 Rev. 1 (12-2022)
Copyright ©2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Introduction
This manual is intended for Christie CIC 1DLP Camera which can be installed in below models:
• DWU880-GS, DWU880A-GS, DWU1100-GS, DWU1100A-GS, DWU1400-GS, DWU1400A-GS
• DWU15-HS, DWU15A-HS, DWU19-HS, DWU19A-GS, DWU23-HS, DWU23A-HS
• 4K13-HS, 4K13A-HS, 4K22-HS, 4K22A-HS
For complete GS Series and HS Series products documentation and technical support, go to
.
Safety and warning guidelines
Read all safety and warning guidelines before installing or operating the Christie CIC 1DLP Camera.
This product must be operated in an environment that meets the operating range specification.
Product labels
Learn about the labels that may be used on the product. Labels on your product may be yellow or
black and white.
Warning!
If not avoided, the following could result in death or serious injury.
• Do not expose the product to moisture.
• Do not operate the product without all of its covers in place.
• Do not allow anything to rest on the power cord.
• Always provide proper ventilation for the product to prevent overheating.
Caution!
If not avoided, the following could result in minor or moderate injury.
• Only Christie qualified technicians are permitted to open product enclosures.
• All procedures must be performed by Christie qualified technicians.
• ELECTRICAL and BURN HAZARD! Use caution when accessing internal components.
Notice.
If not avoided, the following may result in equipment or property damage.
• SHOCK HAZARD! Only use the AC power sources recommended by Christie for use with the product.
• Do not insert foreign objects or liquids into the product.
• Do not use chemical cleaners to clean the product.
• Do not drop the product.
• Only use cleaning solutions recommended by Christie. All other cleaning solutions may cause
product damage and void the warranty.
