Lens mount
components
Lens mount provides a means of securing a projection lens to the projector. Components include the
lens boot, lens mount barrel, and the lens mount offset.
Removing the lens boot
The lens boot is a critical part of the projector's electromagnetic interference (EMI) enclosure and is
required to meet FCC standards for radiated emissions. It also helps to keep out dust and foreign
materials.
Estimated replacement time: 8 minutes
1. Remove the front cover (on page 33).
2. Remove the two screws securing the lens contact board.
3. Disconnect the harness.
4. Remove the lens contact board.
5. To release the boresight indicator brackets and lens boot, remove eight screws.
6. Remove the lens boot and boresight indicator brackets.
7. Replace the lens boot and/or the boresight indicator brackets.
8. To install the lens boot and boresight indicator brackets, repeat these steps in reverse order.
Removing the lens mount barrel
The lens mount barrel is the housing for the projector lens.
Estimated replacement time: 18.5 minutes
Boxer 4K Service Guide
87
020-101699-04 Rev. 1 (02-2018)
Copyright
©
2018 Christie Digital Systems USA, Inc. All rights reserved.
Summary of Contents for Boxer 30
Page 1: ...Service Guide 020 101699 04 Boxer 4K...
Page 113: ......
