Christie 130-002103-01, User Manual

Page: 129 / 144

Serial Command Reference
Matrix StIM™ WQ/SIM WQ User Manual 117
020-100883-01 Rev. 2 (06-2013)
Select Input (SIN)
GPIO Events:
(RTE G "XXXXXXX" "description" "(PWR 1)") Turn ON the projector if we receive any GPIO Input.
(RTE G "" "description" "(PWR 1)") Turn ON the projector if we receive any GPIO Input.
(RTE G "XX" "description" "(PWR 1)") Turn ON the projector if we receive any GPIO Input.
(RTE G "XXXXXLH" "description" "(PWR 0)") Turn OFF the projector if pin 6 is set to low and pin 7 is high.
(RTE G "HH" "description" "(FRZ 0)") Freeze the image if pins 1 and 2 are set to high.
(RTE G "XXHHXXH" "description" "(FRZ 0)") Freeze the image if pins 3,4,7 are set to high.
(RTE G "LLHXX" "description" "(FRZ 0)") Freeze the image if pins 1,2 are set to Low and pin 3 is set to high.
(RTE G "LLH" "description" "(FRZ 0)") Freeze the image if pins 1,2 are set to Low and pin 3 is set to high.
SIN
CONTROL GROUP:
Preference
SUBCLASS:
Power Down
ACCESS LEVEL:
Operator
Description
Selects the active input. The projector has 2 input DVI connectors and 2 video paths. This control assigns which
video path uses which DVI input. The parameter value designates interface followed by a 1. To select DVI 1 use
11. To select DVI 2 use 21.
Subcode
MAIN Description of Use
Set the active Input for the main video.
SECD Set the active Input for the secondary video.
Examples:
(SIN 11) Set main video to DVI connector 1.
(SIN 21) Set main video to DVI connector 2.
(SIN+SECD 11) Set secondary video to DVI connector 1.
(SIN+SECD ?) Report which DVI connector routes secondary input.
RTE