Rotational Vacuum Concentrator RVC 2-33 CDplus
with infrared heating
6 Operation
58 / 105
Version 08/2009, Rev. 3.6 of 22/11/2021
• sb-bs
Translation of the original operating manual
Program memory information
• Select "Program memory information" from the program administration
menu and confirm. Information concerning free program locations and
sections are displayed:
Fig. 39: Program memory information
Pos : 159 /010 Univ ers almodul e/ Leerz eile @ 0\mod_1202116244500_0.docx @ 114 @ @ 1
Pos : 160 /200 Chris t/370 R VC-BA (ST ANDARDM ODU LE)/ 060 Betrieb/CD plus /060-0050-0030- 0030 Sonderfunk tionen @ 25\mod_1404985151906_68. doc x @ 187345 @ 4 @ 1
→
6.5.3.3
Special functions
Pressure increase test
NOTE
The
→
pressure increase test
can only be performed if a vacuum sensor
is installed.
Entering the set values
• Select "Special functions" from the main menu.
• Open the menu "Pressure increase test" and select "Parameter
pressure increase test".
• Enter the set values, confirm and quit the menu.
Performing the pressure increase test
• Select "Special functions" from the main menu.
• Open the menu "Pressure increase test" and select "Start pressure
increase test".
The pressure increase test will be performed. The test time progress and
the measured pressure increase are displayed in a graphical form.
Fig. 40: Graphical presentation of the pressure increase test
When the test is finished, an information window pops up and shows the
result of the pressure increase test.
Pos : 161 /010 Univ ers almodul e/ Seit enwechs el @ 0\mod_1202116244312_0.docx @ 105 @ @ 1
