Model ATF End Control with Sensor Plus
1. Attach one Swinging Pan Support (item 4) and three regular Pan Supports (item 2) to Pan Shield (item 3) using
rivets supplied. Always attach the Swinging Pan Support (item 4) at the same location on all Pan Shields (item
3). It will be necessary to support the Pan Shield (item 3) while installing the rivets. Use a hammer to drive
rivets as shown in Figure 1.
Figure 1. Assembling the Pan Supports to the Pan Shield
2. Install the Sensor Switch Assembly (item 1) to the Drop Tube (item 3) using the included #8 Hex Washer Head
Screw (item 2).
Figure 2. Installing the Sensor Switch Assembly to the Drop Tube
3. Install the Drop Tube Assembly (item 2) to the Pan Shield Assembly (item 1) by routing the Drop Tube
Assembly (item 2) up through the center of Pan Shield Assembly (item 1). Make sure the cord from the Sensor
Switch Assembly passes through the hole in the side of the Pan Shield Assembly (item 1).
Figure 3. Assembling the Drop Tube to the Pan Shield Assembly
Model ATF™ End Control with Sensor Plus™
Part Number 42343
and
Model ATF End Control Update Kit
Part Number 43711
1630-11 11/99
2
1
3
4
Item
Description
1
Wood Block
2
Pan Support
3
Pan Shield
4
Swinging Pan Support
1630-2 11/99
1
1
2
3
Item
Description
1
Sensor Switch Assembly
2
#8 Hex Washer Head Screw
3
Drop Tube
2
1
1630-3 11/99
Item
Description
1
Pan Shield Assembly
2
Drop Tube Assembly
MF1630B
December 2000