IT
If the refrigerator is installed in the moisture place, make sure to check whether the ground wire and leakage circuit
breaker are normal. If vibration noises are produced due to the refrigerator contacting the wall or if the wall gets blackened
by air convection around the compressor, move the refrigerator away from the wall. Setting up the refrigerator may cause
jamming noise or image chaos to the mobile phone, fixed-line telephone, radio receiver, television surrounding it, so try to
keep the refrigerator as far away as possible in such case.
IV.
Functions
When the refrigerator system is powered on for the first time, all icons on the display panel gets illuminated for 2s, and the
system runs at 4
℃
by default.
1
.
Functions
1.1 Temperature setting
Temperature can be adjusted by pressing the ‘SET’ key, and if no key operation within 3s after temperature setting, the
said setting will be validated, with the temperature immediately controlled as per the setting; and the mode indicator light
will go off after 3 seconds.
The temperature modes cycle as following: “2→4→5→6→8→FAST COOL→2”
In the spring and autumn seasons when ambient temperatures range between 16-35
℃
, it is advisable to set the
temperature at Mode 4, 5 or 6, and adjust the air regulating lever to the MID. position.
In summer when ambient temperature is above 35
℃
, it is general to set the temperature at Mode2, and adjust the air
regulating lever between MID and MIN.
In winter when ambient temperature is at or below 16
℃
, it is general to set the temperature at Mode 2, and adjust the air
regulating lever between MAX and MID., with MAX. or approaching the Max. being preferable.
1.2 “FAST COOL”
Cooling down the temperature in a rapid manner is beneficial to the prevention of food nutrition against lost and the
preservation of freshness.
After a cumulative running period of 3 hours, the fast cooling function will exit automatically, with the temperature mode
restored to that set before the fast cooling function is enabled.
1.3 Door open alarm
When the fridge door keeps open for more than 10 minutes, the LED lamp begins flashing for alarm purpose, which will
not stop until the said door is closed.
1.4 Power cut memory
In case of power failure, the refrigerator will maintain the operating state before power failure when power supply is
restored.
1.5 Power-on delay
In order to protect the refrigerator compressor from being damaged in the case of short-time power failure (i.e., less
than 5 minutes), the compressor will not be started immediately after it is powered on.