Chipatronic
P 07 5442 3688
W chipatronic.com.au
1.
Test a Camera
1.1 Insert the 4 pin test cable into the
Video In
socket on the right side of the tester (yellow socket).
1.2 Connect the camera to the 4 pin connector on the other end of the test cable and turn
the power switch ON. Note that the centre position is OFF.
1.3 The LCD will display the image from the camera if it is working correctly.
With a CVBS camera this will be shown in the upper left hand corner as
ANALOG
.
With an AHD camera this will be shown as
AHD
with resolution of the camera.
There is no selection required between CVBS or AHD, the tester detects the video
mode automatically.
2.
Test a Monitor
2.1 Using the same test cable, attach a 4 pin Female-to-Female gender changer (
CH-4PF2F
) to connect
to the input of a 4 pin monitor.
For an RCA input monitor use a 4 pin female to RCA adaptor (
CH-4FRCAM
).
These adaptors are available as accessories and are not included with the tester.
2.2 Depending on the monitor, power may not be required as the tester outputs 12V through the cable
and some monitors can be powered through this from the tester. Generally the monitor will be installed
and power will be supplied from the vehicle.
2.2 Switch the tester ON and then go to the MENU button located on the top of
the tester. Press the Menu button twice and
COLORBAR SIGNAL
will be
displayed. Press one of the arrow buttons to select the output required. The
options will cycle through each time the arrow is pressed. With Auto Select
monitors the signal is not usually important as they will work with PAL or
NTSC but other monitors may be set to a specific format.
The colourbar output should be displayed on the monitor being tested.
3.
Charging
The charging input is next to the switch on the left side.
Plug the charging cable into the tester and connect to a USB charger, computer or
other USB power source. The small red indicator will show when it is charging.
CH-CTAHD5
Basic User Guide for Vehicle Cameras and Monitors
Please read the instructions prior to use.
●
Do not use this device in the rain or in wet conditions as it
may be damaged by water ingress.
●
Do not use chemical cleaners on the screen or the case as
this may damage the device.
●
Use only the included USB charging cable to charge the
internal battery.
●
Ensure that the battery is sufficiently charged before use as
low power may lead to damage either to this device or the
device under test.