- 18 -
5-4. Channel-by-Channel Shift Setting
This function is used to shift (parallel shift) the measured value of digital display/recording.
The amount of shift is set on a channel to channel basis.
1. Setting procedure
(1) Select shift setting
Pressing the
key changes adjustment item. Select
.
(2) Select channel number
Pressing the
/
key advances/reverses channel number. Select a desired channel number by
pressing the
key.
(3) Start
setting
Pressing the
/
key displays the cursor (flashing decimal point).
(4) Move
cursor
Press the
key to move the cursor right.
(5) Set
numeric
value
Pressing the
/
key increases/decreases numeric value.
(6) Set (change) desired measured value
Repeat above steps (4) and (5) to set a desired value.
(7) Check
display
Press the
key after the rightmost digit is set. Decimal points of all digits will flash.
(8) When set value is correct
Press the
key. An error judgment is made and the set value is registered if no error is found. After that,
go back to step (2).
(9) Error judgment display
If the display shows
or
, it indicates that the set value is out of the setting range or a format error
occurs. In this case, press the
key to reset.
(10) How to end
Press the
key and select
, and then press the
key.
The mode changes to the operation mode when the
key is pressed on the passcode entry window
(
).
A shift value should be within 2% of the scale width
(maximum value – minimum value).
Setting range of shift
Note 1
You cannot view a reflected shift set value.
Check of set value
Note 2