chiliGREEN W25BBZ W8, User Manual, Page: 139 / 312

Modules & Options
PC Camera Module 7 - 3
7
PC Camera Module
Before installing the PC Camera driver, make sure that the optional PC Camera is
on. Use the Fn + F10 key combination (see “Function/Hot Key Indicators” on
page 1 - 18 ) to toggle power to the PC Camera module . Make sure you install the
drivers in the order indicated in Table 4 - 1, on page 4 - 3 .
Note that only 14.0" / 35.56cm Model A computers require a camera driver for
Windows 8.
When the 14"/35.56cm screen Model A PC Camera is in use the power LED indi-
cator will blink orange (see Table 1 - 2, on page 1 - 12 ).
When the Model B/C PC Camera is in use the LED indicator to the left of the camera will be
illuminated in red (see Figure 1 - 5 on page 1 - 10 ).
There are a number of different camera modules available with this computer model
series. You will have the appropriate application installed for your camera.
Make
sure you access the application via the desktop shortcut .

Latest PC Camera
Driver Information
Check the Device Drivers
& Uti User’s Manu-
al disc
and any accompa-
nying insert pages, for the
latest updated information
on the PC Camera driver,
which may override the in-
formation provided here.
PC Camera Display
The PC Camera applica-
tion software needs to be
run while the
default note-
book LCD is the selected
display device.
After a camera picture is
obtained on the default
notebook LCD, you may
then use the
Fn + F7 to tog-
gle through the display
modes (give the screen
time to refresh).
2

PC Camera Application and Power-Saving States
If the computer enters Sleep or Hibernate mode while running the camera application, the
program will stop running, and will need to be restarted when the system resumes from the
power-saving state.