I-DSSRINST.doc
Page 1 of 8
Childforms®
I-DSSRINST
DOUBLE SEAT FUN RIDER™
Assembly Instructions
Please note the illustrations may differ from style received. All assembly instructions
are the same, regardless of which “style” spring rider you received
.
Please read and follow all
Safety Information
.
Please review assembly and component
Diagrams
.
Verify
component
&
hardware
quantities received.
Familiarize yourself with the
installation procedures
.
Safety
Please follow assembly procedure in the correct order.
Play site ground material should only be of an approved, shock-absorbing
type and meet minimum depth requirements.
NEVER
install playground
equipment over paved or hard surfaces.
Please be sure that all fasteners are used in the proper location.
Be sure that minimum fall zone requirements are met.
Do not allow children to play on or near equipment which is in need or
repair or replacement, is incomplete or is otherwise considered unsafe.
1)
Parts Inventory and Set-Up
Note: plastic center and side panel design may vary from those depicted.
Confirm that all components, hardware and special tools are included (see
Parts List
).
Gather any addition tools necessary for installation (hex driver, level, tape measure, etc)
Please follow diagrams and instructions in order.
