ASSEMBLY / OPERATING INSTRUCTIONS
To install Safety Gate (continued)...
6
7
8
9
10
Centre the gate in opening with bottom rail resting on
floor.
Gaps on each side should be equal.
Pull out the two bottom spindles (c) until they touch
the mounting surface and rest on top of floor
moulding (if applicable).
Tighten handwheels TOWARD GATE FRAME as tightly
as possible.
Each spindle adjusts individually and may be
extended to varying lengths to allow for moulding,
uneven walls, etc.
Close walk through door so it is aligned directly above
bottom gate rail.
Pull out top spindle (a) on the hinge side (h) until it
touches mounting surface.
Tighten handwheel TOWARD GATE FRAME.
Pull out top spindle (a) on handle side until it touches
mounting surface and tighten handwheel TOWARD
GATE FRAME.
Take turns tightening both top spindles until tension is
reached and the distance between the handle and
frame is 0.80mm.
To open gate: Pull back release button (i) on handle.
Lift gate door and swing open.
6a.
6b.
7a.
7b.
7c.
8a.
8b.
8c.
9a.
9b.
10a.
IMPORTANT:
The gate must be level and straight up and down, otherwise the gate’s
self closing door will not function properly.
.80mm