16
Assembly / Operating Instructions
Co-sleeping mode (fixing to the bed cont)
4
5
7
6
8
Move the sleeper close to the parent’s bed and check the height of the sleeper compared with the mattress on
the bed. The side support of the sleeper should always be placed close to the parent’s mattress and the mattress
should always be aligned with the height of the side support for restraint of the sleeper.
In order to fix the crib to the parent’s bed in co-sleeping mode, use the attached pair of fixing belts provided. The
fixing belts can be found in the lower pocket of the fabric lining.
Tighten the loop by pulling the belts firmly. Adjust the belts separately until the sleeper is firmly in contact with the
parent’s mattress.
Slide the straps between the top mattress and the base using a back and forth ‘sawing’ motion and at the same
time pulling downward until the straps and anchor plates are in the desired position.
Store any excess of belts inside the pocket positioned on the bottom of the fabric lining.
WARNING:
In the co-sleeping mode the two legs of the sleeper should always be
adjusted to the same height.
WARNING:
Ensure the fixing belts are straight.