Chiko CBA-080AD, Instruction Manual

Page: 36 / 47

Chapter
4 Maintenance and Checkup
34
4.2
Replacing Fuses
Replace one fuses if any of them is blown by an overcurrent due to trouble with internal equipment.
The fuses are contained in the black box beside the power switch.
The replacing fuses should be those designated by CHIKO AIRTEC.
Designated fuses : 218 Series from Littell fuse [250V 10A]
1.
Take out the black box beside the power
switch.
If it cannot be taken out smoothly, please
use a flathead screwdriver or other thin-
tipped tool to take it out carefully.
2.
Remove the fuses out of the fuse box and
replace with new ones.
4.3
Daily Checkup
Check item Frequency Check that:
Filter case Before operation Filter case is completely closed.
Suction port Before operation Suction port is not blocked.
Exhaust condition Daily Exhaust port is not blocked.
Operation panel condition Daily Error or warning is not displayed.
4.4
Daily Care Method
CAUTION
• Be sure to disconnect the plug from the power outlet and confirm that the
device is not operating.
• In case the exterior of the device is dirty, wipe it gently with a soft cloth or a tightly squeezed cloth that
will not make any damage on the device easily.
• To remove severe dirt, wet a cloth with neutral detergent diluted with water and wipe it gently.
• Benzine, thinner, gasoline or cleanser must not be used.
Cover Fuse