Chiko CBA-080AD, Instruction Manual

Page: 32 / 47

Chapter
3 Operation
30
Chapter 3
Operation
3.1
Start-up Preparation
3.1.1
Installation
■
Installation location
To ensure operating safety and deliver the full performance of the device, install the device in a location
that meets the following conditions:
Item Description
Ambient temperature 0° to +35°C
Ambient humidity 80 RH% or lower (without dew condensation)
Ambient conditions Indoors (not exposed to direct sunlight), free of corrosive/flammable gases,
oil mist, and dust.
3.1.2
Wiring and Piping
■ Wiring
WARNING
• Perform wiring firmly, without bending or pulling cables with excessive force.
Fire or electric shock may result.
• Ensure that the power supply conforms to the specifications of the device.
• Be sure to connect the ground wire.
CAUTION
• Avoid multiple connections as they can cause voltage reduction.
At reduced voltage, the device may fail to operate normally, resulting in
failure.
The device is powered by a single-phase supply.
The tolerance of the supply voltage is

10%.
1.
Connect the device attachment plug of the power cord to the power connector on the device.
2.
Connect the power supply end of the power cord to the power outlet.
■
Piping
1.
Turn the removable flange clockwise until it is
secured on the suction port.
2.
Connect the suction tube (to be prepared
separately) to the removable flange.
IMPORTANT
• Ensure appropriate piping during operation.
The piping should be as short as practicable, with the piping port diameter not too
small.
Removable flange