Page 3
SKU 90880
7.
Use eye, nose and mouth protection. Always wear ANSI approved impact safety
goggles. Wear an ANSI approved dust mask or respirator when working chemical
and paint dusts and mists.
8.
Do not overreach. Keep proper footing and balance at all times. Do not reach over
or across running machines.
9.
Maintain tools with care. Keep tools clean for better and safer performance. Follow
instructions for lubricating and changing accessories. Inspect tool cords periodically
and, if damaged, have them repaired by an authorized technician. The handles must
be kept clean, dry, and free from oil and grease at all times.
10.
Disconnect power. Unplug Battery Charger when not in use.
11.
Avoid unintentional starting. Be sure the switch is in the Off position when not in
use and before plugging Battery in. Do not carry any tool with your finger on the
trigger.
12.
Stay alert. Watch what you are doing, use common sense. Do not operate any tool
when you are tired.
13.
Check for damaged parts. Before using any tool, any part that appears damaged
should be carefully checked to determine that it will operate properly and perform its
intended function. Check for alignment and binding of moving parts; any broken parts
or mounting fixtures; and any other condition that may affect proper operation. Any
part that is damaged should be properly repaired or replaced by a qualified
technician. Do not use the tool if any switch does not turn On and Off properly.
14.
Replacement parts and accessories. When servicing, use only identical
replacement parts. Use of any other parts will void the warranty. Only use accessories
intended for use with this tool. Approved accessories are available from Harbor
Freight Tools.
15.
Do not operate tool if under the influence of alcohol or drugs. Read warning
labels if taking prescription medicine to determine if your judgment or reflexes are
impaired while taking drugs. If there is any doubt, do not operate the tool.
16.
Maintenance. For your safety, service and maintenance should be performed
regularly by a qualified technician.
17.
Pacemaker safety warning. People with pacemakers should consult with their
physician(s) before using this product; operation of equipment in close proximity to a
heart pacemaker could cause interference or failure of the pacemaker.
18.
Use tools with both hands when required. Many tools such as chain saws, drills,
routers, etc., require the use of both hands when operating. This helps maintain tool
stability and keeps hands away from the working area of the tool.
Note: Performance of this tool may vary depending on variations in battery power.
Warning: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be under-
stood by the operator that common sense and caution are factors which cannot be
built into this product, but must be supplied by the operator.
