Chicago Dryer King Edge VAc, Instruction Manual

Page: 21 / 302

King Edge Vac Installation
2-3
Compressed air that is clean and dry must
be provided for the unit. This is very important
because the air will blow directly on the flatwork.
The compressed air supply must meet the
pressure and air flow requirements noted in the
APPENDIX , Technical Specifications .
The electrical requirements of the spreader/
feeder are shown on the nameplate (Figure 2-
2), located on the back of the right endframe.
Additional information can be found in the
APPENDIX , Technical Specifications . Wiring
and a separate, fused disconnect switch of suitable
size must be locally supplied if local codes require
one. Check local codes for clearance requirements
to any electrical box.
2.2 Installation
Procedures
The spreader/feeder should be moved on
its casters whenever possible. When this is
impractical, and when removing it from the skids,
be sure that it is handled only by qualified riggers
using proper equipment.
Installation of the spreader/feeder includes:
Inspection
Uncrating, Placement and Alignment
Discharge Conveyor Attachments
Floor Trough Installation
Inlet Conveyor Upper Pulley Installation
Compressed Air Supply Connection
Electrical Connection
Inspection
NOTE: Notify the carrier if
any damage has been done
to the spreader/feeder during
shipment.
It is in the interest of the buyer to carefully
inspect all shipments before they are accepted
from the carrier. Upon delivery, be sure that all
items listed on the bill have been received.
Any shortage, breakage, or damage noticed at
the time of delivery should be indicated on the
carrier’s freight bill and signed by the driver or
carrier’s representative.
Damage noticed after delivery should be
reported to the carrier at once. Request their
inspection of the shipment and fill out a concealed
damage inspection report.
•
•
•
•
•
•
•
Figure 2-2: The nameplate gives important
information about the unit.
TOC INDEX