Chicago Dryer Edge MAXX, Instruction Manual

Page: 59 / 288

Edge MAXX Preventive Maintenance
4-3
Check Safety Equipment
Perform only when the unit is
RUNNING.
Use extreme caution.
The unit should never be operated without
all safety guards in place and all safety devices
working properly.
Check that all six red EMERGENCY STOP
buttons, the crossbeam sensors and the mass
sensors at both operator stations bring the
operation of the unit to a complete halt. For
more information, refer to the OPERATING
GUIDELINES chapter, Daily Operating
Procedures section, Start-Up procedure.
NOTE: Repair any faulty safety
devices before continuing to
operate the unit.
4.2 Weekly PM (50 hours)
WARNING
Do not repair or correct any
of these conditions without
reading and understanding
the Repair chapter.
Only qualified personnel
should troubleshoot and
repair this unit.
Make sure the power is
turned OFF at the main
disconnect switch.
Follow lockout/tagout
procedures approved for
your site. Follow local
regulations. Failure to do so
could result in serious injury.
TOC INDEX