Chicago Dryer Edge MAXX, Instruction Manual

Page: 48 / 288

Operating Guidelines Edge MAXX
3-8
3.3 Daily Operating
Procedures
In the daily operation of the unit, it is desirable
to follow consistent operational procedures.
By training operators to follow the same set of
guidelines for daily procedures, operator safety
and efficiency are maximized. This unit requires
only one operator.
General daily routines include:
Start-Up
Interconnected Stop Circuit (option)
Operation Notes
Flatwork Handling
Handling Jams and Misfeeds Safely
Shut-Down
Methods of processing specific flatwork are
covered in the Operating Techniques section,
which follows this discussion of standard
routines.
WARNING
Never run a unit when
ribbons are missing or
broken. Serious damage and
injury could result.
•
•
•
•
•
Start-Up
The following steps are suggested for start-up
of the spreader/feeder each day.
Perform all daily preventive maintenance
and cleaning procedures. For more in-
formation, refer to the PREVENTIVE
MAINTENANCE
chapter,
Daily PM
section.
Have flatwork fully washed and extracted,
sorted, and ready to process.
Turn ON the compressed air supply to
the unit.
Turn power ON at the main disconnect
switch.
Press the green Start button. The indica-
tor lamp in the switch lights and the CHI
Panel begins its start-up diagnostics. Then,
all rotating and conveying elements begin
to operate.
NOTE: If the unit is part of a
line with the Interconnected Stop
Circuit option, turn power ON at
the main disconnect switch to
each of the other machines in the
line.
1.
2.
3.
4.
5.
TOC INDEX