Chicago Dryer Edge MAXX, Instruction Manual

Page: 21 / 288

Edge MAXX Installation
2-3
2.2 Installation
Procedures
Installation of the unit includes:
Inspection
Uncrating and General Placement
Input Conveyor Installation
Compressed Air Supply Connection
Final Positioning/Easi-Glide Preparation
(Option)
Reject Conveyor Positioning
Electrical Connection
Inspection
Carefully inspect all shipments before they
are accepted from the carrier. Upon delivery,
make sure all items listed on the bill have been
received.
Any shortage, breakage, or damage noticed at
the time of delivery should be indicated on the
carrier’s freight bill and signed by the driver or
carrier’s representative.
Damage noticed after delivery should be
reported to the carrier at once. Request their
inspection of the shipment and fill out a concealed
damage inspection report.
NOTE: N o t i f y t h e c a r r i e r
immediately if any damage has
been done to the unit during
shipment.
•
•
•
•
•
•
•
Compressed air that is clean and dry must
be provided for the unit. This is very important
because the air will blow directly on the flatwork.
The compressed air supply must meet the
pressure and air flow requirements noted in the
APPENDIX , Technical Specifications .
The electrical requirements of the spreader/
feeder are shown on the nameplate, located on
the back of the right endframe (Figure 2-2).
Additional information can be found in the
APPENDIX , Technical Specifications .
Wiring and a separate, fused disconnect
switch of suitable size must be locally supplied
if local codes require one. Check local codes for
clearance requirements to any electrical box.
Figure 2-2: The nameplate provides information
on the unit’s electrical requirements.
TOC INDEX