Chicago Dryer Edge MAXX, Instruction Manual

Page: 144 / 288

Repair Edge MAXX
7-12
Figure 7-12: Transfer clamp assembly at the center
of the unit.
A
C
B
Transfer Clamp Assembly
Replacement
Removing the Assembly
Required Tools
7/16” wrench, 1/8”, 3/16” Allen keys,
Phillips screwdriver, Loctite
®
243
thread lock
Perform only when the unit is OFF
with power disconnected.
Turn power OFF at the main disconnect
switch.
Turn OFF the compressed air supply to
the unit and make sure the system is de-
pressurized.
Detach the air cylinders from both sides
of the transfer clamp assembly:
Remove the nut and bolt which secure
one end of the air cylinder to the jaw
(Figure 7-12, A). Save.
Remove the nut, bolt and flat washer
which secure the other end of the air
cylinder to the transfer clamp body
(Figure 7-12, B). Save.
Place the cylinder aside, with its air
hoses still attached.
Repeat Step 3 a) to c) with the second
air cylinder.
Remove the four screws from the bottom
of the transfer clamp assembly (Figure
7-13).
Remove the entire assembly and place on
a work table.
Remove the rollers and attaching hardware
(Figure 7-12, C). Save. Note these rollers
are not included on the blanket model.
1.
2.
3.
a)
b)
c)
d)
4.
5.
6.
Installation
At the work bench, the flexible nose piece
(Figure 7-12, C) to the new transfer clamp
assembly with the hardware removed
earlier.
NOTE: Use only Loctite® 243
thread lock on the screws to
secure the attachment of the
transfer clamp assembly to the
rodless air cylinder. Other types
of Loctite dry too hard and are too
difficult to remove.
Coat threads of the new screws that
shipped with the assembly with Loctite
®
243.
1.
2.
Figure 7-13: Transfer clamp assembly mounting
screws.
TOC INDEX