Cheyenne BURRO Step-By-Step Instructions Download Page 1

Thank you for choosing our product 

 

                    BURRO HAND CART 

 

 

Cheyenne Livestock & Products Inc. 

PO Box 25 

 

 

 

 

 

 

 

            Telephone: (360) 574-7771 or 1-800-424-7575 

Brush Prairie, WA 98606   

 

 

 

 

 

 

         Fax: (360) 574-0490 

 

STEP BY STEP INSTRUCTIONS FOR THE 

BURRO

” HAND CART

 

NOTE

:   

ALL BOLTS SHOULD BE PLACED WITH THE SLOTTED HEAD ON THE INSIDE OF THE CART.

 

HARDWARE PACKAGE:

 Please find and check the hardware package. See the pictorial inventory of the assembly hardware 

on the back of these instructions. 

TOOLS REQUIRED

 (not included): A flat blade screwdriver and a 7/16th end wrench or an adjustable jaw wrench. 

1.

 

LEGS:

  Turn the cart body 

(PART “A”)

 on its side. Match the number 

on the leg (PART “E”)

 to the number on 

the cart. Use (4) of the 1 ½ inch bolts 

(PART “G”)

, and (4) self-locking 1/4-inch nuts 

(PART “H”)

 to attach the leg 

to the cart body. 

 

2.

 

AXEL BRACKETS:

 With the cart remaining on its side, use the (8) 1 ¼ inch long bolts 

(PART “F”)

, and (8) self-

locking nuts to attach both axel brackets 

(PART “J”)

 to the bottom of the cart. IMPORTANT! Do not tighten the 

bolts more than finger tight.  

 

3.

 

AXEL:

 Turn the cart body upside down. Slide the axel 

(PART “C”)

 through both axel brackets. Be sure that the 

same amount of axel protrudes beyond the sides of the cart on both sides (about 3-3/8 inches) to allow for the 
wheels. 
 

4.

 

WHEELS:

  Put one collar 

(PART “K”)

 on each end of the axel, then the wheels 

(PART “B”)

, followed by another 

collar. Now tighten the set screws of the collar. Tighten the bolts that hold the axel brackets to the cart body. 
See drawing 1 
 

5.

 

HANDLE: 

 Turn the cart body upright on its wheels. Match the numbers on the handle 

(PART “D”)

 to the 

numbers on the cart body. Install the handle on the outside of the cart body using the last four (4) 1 ½ inch 
long bolts, (4) flat washers 

(PART “I”)

 and (4) self-locking nuts. Install the flat washers and the head of the 

bolts on the inside of the cart.  

 

The diagram below shows the cart in an upside-down position. 

 
 

 

 

 

Reviews: