Chevrolet Low Cab Forward Owner Manual (GMNA-Localizing-U.S.-
10399647) - 2016 - crc - 5/25/16
282
Vehicle Care
Roofmarker Lamps
1. Loosen the screws (2) and
remove the lens (1).
2. Remove the bulb (3) from the
socket (4) and replace it with a
new one.
3. To install the lights, follow the
removal procedure in reverse.
If the screwing procedure is
inadequate, water may infiltrate into
the lamp unit.
Sidemarker Lamps
(Including Turn Signal
and Cornering Lamps)
Do not replace a bulb with other
than the specified wattage. This will
cause abnormal flashing,
particularly for turn signal lamps.
When replacing a bulb, make sure
the light switch is "OFF".
1. Open the front door, remove
the rubber cap (1) in the lower
part of the door, and loosen
the nut (2).
2. Slide the cornering lamp (3)
and the side turn signal lamp
forward relative to the vehicle.
Disconnect the clip (1) on the
lamp
’
s rear side from the door
panel (2) and pull out the lamp.
If you pull out the light rear
section by too much when
removing the clip on the rear
side, the clip on the lamp front
side may be damaged.