Chevrolet CORVETTE, Owner'S Manual

Page: 121 / 319

Chevrolet Corvette Owner Manual (GMNA-Localizing-Europe-15352645) -
2022 - CRC - 6/22/21
120 Lighting
When it is bright enough outside, the
headlamps and parking lamps will turn off
or may change to Daytime Running
Lamps (DRL).
The automatic headlamp system turns off
when the exterior lamp control is turned to
O
or the ignition is off.
To turn automatic headlamp system back
on, turn the band to
O
again, then
release it.
If the automatic headlamp system has the
headlamps turned on and you turn the
ignition off, the headlamps will turn off.
When the driver door is opened the
headlamps and parking lamps will illuminate
for a period of time.
The length of the delayed illumination
period can be changed. See
“ Exit Lighting ”
under Vehicle Personalisation 0 110 .
The regular headlamp system should be
turned on when needed.
Lights On with Wipers
If the windscreen wipers are activated in
daylight with the engine on and the exterior
lamp control is in AUTO, the headlamps,
parking lamps, and other exterior lamps will
come on. The time it takes for the lamps to
turn on depends on the wiper speed. When
the wipers are turned off, the lamps turn
off. To disable, move the exterior lamp
control to
O
or
;
.
Headlamp Levelling Control
Automatic Headlamp Levelling Control
If equipped, the inclination of the headlamps
are adjusted automatically based on
vehicle load.
Hazard Lights
The hazard warning flashers warn others
that you have a problem. The button is on
the overhead console.
|
: Press to make the front and rear turn
signal lamps flash on and off. Press again to
turn the flashers off.
The hazard warning flashers work no matter
what mode the ignition is in, even if the
ignition is turned off.
When the hazard warning flashers are on,
the turn signals will not work.
Turn and Lane-Change Signals
An arrow on the instrument cluster flashes
in the direction of the turn or lane change.
Move the lever all the way up or down to
signal a turn.
Raise or lower the lever until the arrow
starts to flash to signal a lane change. Hold
it there until the lane change is complete.
If the lever is briefly pressed and released,