Chevrolet 10 Series 1968, Service Manual, Page: 97 / 713

BODY IB-30
F ig .
71
- Dash Mat and Seal
e. Speedo-cable at instrument cluster.
f. Loosen the metal electrical harness shield on the
toe pan.
g. Headlamps.
h. Heater distributor and outlet ducts. Do not re­
move the heater.
DOORS
FRONT SIDE DOOR (Fig. 72)
Trim Panel and Hardware (Fig. 73)
Rem oval
1. Remove window regulator handle and washer by loos­
ening set screw and pulling from shaft.
2. Remove inside door handle and washer by loosening
set screw and pulling from shaft.
3. Remove trim panel-to-door inner panel screws and
remove trim panel.
4. Remove arm rest by removing two screws.
Installation
1. Install arm rest and attaching screws to trim panel.
2. Align holes in trim panel with holes in door inner
panel.
3. Install washer on shaft and with end of door inner
handle pointing forward, align serrations in both
handles with shaft serrations and install set screws.
Window Glass
The optional window glass in the rear and side cargo
doors may be replaced as outlined on Page 14.
The front side door window glass may be removed and
installed as outlined below:
Removal
NOTE: Do not remove arm rest.
Fig. 72 - Front Side Door
1. Remove window regulator handle, door inside handle
and remove trim panel as indicated under ’’Trim
Panel and Hardware” above.
2. Remove door bottom channel retainer screw (fig. 74).
3. Roll window to full down position and push rear chan­
nel retainer to one side (fig. 75).
4. Tilt window glass forward and disengage regulator
roller from guide rail (fig. 76).
5. Tip rear edge of glass upward and remove (fig. 77).
Installation
1. With regulator arm in full down position, insert glass
(vent side downward).
CHEVROLET TRUCK SERVICE MANUAL