Chevrolet 10 Series 1967, Service Manual

Page: 85 / 605

BODY 1B-23
Fig. 51 - Instrument Panel Compartment w/Door
Installation
1. Slide the compartment into position and loosely in­
stall the six screws.
2. Position the compartment and tighten all screws.
3. Place door in opening so hinge holes are aligned,
loosely install hinge screws and insert check rod in
hole at side of compartment.
4. Adjust door for fit in the opening and tighten screws.
DASH MAT (Fig. 52)
Replacement
Remove the dash mat by cutting off the plastic fasteners
with a sharp knife. New fasteners are required to install
the m at Before installing the fasteners, make certain
that each fastener is provided with an adequate supply of
sealing compound. Parts to be removed and installed for
replacement of the dash mat are as follows:
a. Windshield washer hoses from wiper motor.
b. Windshield washer bag bracket.
c. Electrical harness from the quick disconnect
under dash.
d. Junction block.
e. Speedo-cable at instrument cluster.
f. Loosen the metal electrical harness shield on the
toe pan.
g. Headlamps.
h. Heater distributor and outlet ducts. Do not re­
move the heater.
DOORS
FRONT SIDE DOOR (Fig. 53)
Trim Panel and Hardware (Fig. 54)
Removal
1. Remove window regulator handle and washer by
loosening set screw and pulling from shaft.
2. Remove inside door handle and washer by loosening
set screw and pulling from shaft.
3. Remove trim panel-to-door inner panel screws and
remove trim panel.
4. Remove arm rest by removing two screws.
Installation
1. Install arm rest and attaching screws to trim panel.
2. Align holes in trim panel with holes in door inner
panel.
3. Install washer on shaft and with end of door inner
handle pointing forward, align serrations in both
handles with shaft serrations and install set screws.
Window Glass
Fig. 52 - Dash Mat and Seal Fig. 53 - Front Side Door
CHEVROLET TRUCK SERVICE M ANUAL