Chevrolet 10 Series 1967, Service Manual

Page: 77 / 605

BODY IB-15
Removal and Installation
1. Raise door window and remove door trim pad.
2. Remove bolts securing remote to door inner panel.
3. Pivot remote inboard slightly, to disengage connect­
ing rod, and remove remote from door.
4. To install, reverse removal procedure.
NOTE: Connecting rod can be removed at this
point by disconnecting spring clip from lock.
REAR WINDOW WEATHERSTRIP
Replacement
1. Using a pointed tool, raise one end of the weather­
strip retainer until it is far enough out to take hold
of by hand. Then pull retainer out of its channel all
around the window.
2. From inside the cab, carefully push the window glass
out through the rear of the opening.
Fig . 36 - Installing W eatherstrip Insert w ith J-2189
NOTE:
The weatherstrip may remain in the
window opening during removal of glass. To
remove weatherstrip, merely pull it off the
edges of the door panels. On installation of new
weatherstrip, clean opening edge thoroughly,
then install with butt ends (lightly coated with
weatherstrip adhesive) at top center of opening.
3. Inspect the inner and outer flanges making sure they
are true and that there are no irregularities around
the window opening. Any irregularities must be
corrected.
4. Assemble the weatherstrip to the opening making
sure the outer channel of weatherstrip is firmly
seated on the edges of the panel all around the
opening.
5. Start one end of the glass into its channel in the
weatherstrip. Using a pointed tool, follow around
the rear lip of the glass channel so it bears against
the rear surface of the glass (fig. 35).
NOTE:
Care should be used in this operation
not to chip the edge of the glass. A pointed
wooden tool, if available, should be used.
Fig . 35 - Rear W indow W eatherstrip Installation Fig. 37 - Cutting W eatherstrip Insert at 4 5 ° Angle
CHEVROLET TRUCK SERVICE M ANUAL
J