Chevrolet 10 Series 1967, Service Manual

Page: 108 / 605

BODY IB-46
Fig. 99 - W indshield W ip er Assy.
1. Crown N u t
7. O uter Washer
2. Lock Washer 8. Inner Washer
3.
W ip er Arm Assembly
9. Shaft Ferrule (Part of
4
.
Knurled Driver
Motor Assembly)
5
.
Rain Shield
10. Retaining Bolts
6.
Shaft Ferrule 11.
Motor Assembly
Retaining N u t
(Includes Bracket)
heater cover panel before fiber board liner may be re­
moved from instrument panel.
DOORS
ADJUSTMENTS
Door Assembly in Cab Opening
Door up and down adjustment in cab opening is provided
by means of floating hinge cap screw tapping plates within
door framing. Horizontal slotted cap screw holes in cab
half of hinge assembly provide the in or out adjustment of
door.
Only the upper portion of door can be adjusted "fore”
and "aft" with the adjustment being at the upper hinge.
NOTE: Before making door adjustments al­
ways remove striker plate assembly (View F,
fig.
1 0 2
) from the cab lock pillar.
In addition to the door lock striker, rear of door is
supported in cab opening on two other strikers, one at top
of door and the other at bottom of door. Lower striker,
which is spring-loaded and self-adjusting is mounted to
bottom of door frame as shown in View D, Figure 102.
The adjacent striker support is mounted on door ledge of
cab as shown in View F, Figure 102.
Upper striker and striker support is employed at top of
door to restrict the up and down movement of door in cab
opening. See Views A and C, Figure 102. A fiber shim
(approx. 0.094" thick) is installed between cab and striker
support (View A, Figure 102) to provide adequate clear­
ance between top of door and cab.
The position and purpose of door upper and lower
strikers must be considered when making door
adjustments.
CHEVROLET TRUCK SERVICE MANUAL