Mymesh Product Sheet
Connect any light, anywhere.
MYMESH-COPD17M
IP66 Rated Compact Passive Infra Red (PIR)
Occupancy Detector & Photocell
(Input: 100-240 Vac 50/60Hz)
This MYMESH-COPD17M Lighting Control has an IP66
rated weatherproof enclosure and can be surface
mounted onto an external wall. Confi gurable for any
room occupancy style, via the Mymesh App.
Installation:
Please read these instructions before installing the
product.
NOTE: MYMESH-COPD17M is compatible with Mymesh
commissioning tools.
To be installed by a competent person with reference
to BS 7671 or equivalent local standards. If in doubt
consult a qualifi ed electrician.
• Plan where the MYMESH-COPD17M is to be located
(see diagram 1). Switch off supply and check for
hidden cables and pipes.
• The detector should be sited so that it is not shaded
from daylight.
• Make sure the power is isolated from the circuit.
• Remove the front cover by by removing the two
screws on the front face of the product.
• The detector should be mounted between 1 and 2.2
metres high, via any of the four pre-drilled mounting
holes only and must be mounted with the cable
entering from below.
• Thread mains cable carefully through the required
membrane entry point.
• The MYMESH-COPD17M should be connected as
shown in diagram 2:
L - Live in. N - Neutral in.
• Replace the front cover ensuring the two screws are
secured.
Operation:
To check the operation of the MYMESH-COPD17M:
• Turn on the supply then after 20 seconds if the sensor
has recognised movement of a person within its
zone of detection the integral red LED on MYMESH-
COPD17M will stay illuminated for 4 seconds before
the red LED turns off .
• Thereafter, every time movement is detected by
MYMESH-COPD17M the integral red LED will stay
illuminated for 4 seconds.
The control also features adjustable time out (time
lag) control and daylight threshold control which are
confi gured by the Mymesh App.
Precautions:
• Do not place the MYMESH-COPD17M near heat
sources, fans or in ventilated ceiling voids.
• MYMESH-COPD17M can be wired in parallel (sharing
the same Live and Neutral).
• Do not place close to, or positioned such
that, any light source points directly into the
MYMESH-COPD17M.
• Ensure wires and cables are securely held within the
connection terminals.
• The MYMESH-COPD17M should be protected by a 5
or 6 Ampere mcb or fuse.
• Disconnect the MYMESH-COPD17M from the circuit
before performing insulation testing of the wiring
circuit.
Status LED blinking sequence:
Normal:
Both LED’s off .
Identifi cation of device:
Red LED blinks.
16/04/20
DAT0071 MYMESH-COPD17M (Issue 01)
