77
After having memorised
the limit switches, drive the
rolling shutter to the opening
position and then perform the
following command sequence:
At the end of the sequence, wait until the rolling shutter is completely lowered. From this
moment onwards the motor moves in “Dead Man” mode.
Carry out the following operations:
• Raise the rolling shutter until it enters into the slat tilting zone (first click).
• Lower the rolling shutter until the slats are at their maximum opening point.
• If you wish, raise the rolling shutter until it reaches an intermediate opening of the slats
(preferred opening position).
• Perform the following confirmation sequence: the rolling
shutter will move in sequence to the three memorised
positions: entry into the slat tilting zone, maximum
opening, preferred opening.
• Raise the rolling shutter until it leaves the slat tilting zone (second click).
• Perform the following confirmation sequence:
The rolling shutter will move in sequence to the
memorised positions.
Functions of the button panel*
Type of Command
Outside of tilting area
In tilting area
UP short (< 1 sec)
Short movement upward
Less light
DOWN short (< 1 sec)
Short movement downward
More light
UP long (between 1 and 2 s)
Completely raised
DOWN long (between 1 and 2 s)
Completely lowered
UP very long (> 2 sec)
Middle position (if previously set)
DOWN very long (> 2 sec)
Entry in tilting area
sequence UP/DOWN or
DOWN/UP fast (0.5 sec)
Middle position (if previously set) or
tilting function activation
-
* see key to symbols and operational notes
SLAT TILTING MECHANISM SETTING
(Not available on Clima RX)
MODE 4
:
Orientable roller shutter with coupling point for tilting
function above the lower limit.
Only for roller shutter type Persyroll / Multiroll / Supergradhermetic / Supernova.
Suitable for centralised control units.
E N G L I S H
PROGR.
FROM THE WHITE WIRE