75
After having memorized the limit switches, drive the rolling shutter to the opening
position and then perform the following command sequence:
At the end of the sequence, wait until the rolling shutter is completely lowered. From this
moment onwards the motor moves in “Dead Man” mode.
Carry out the following operations:
• Lower the rolling shutter until the adjustable slats are completely opened:
• If you wish, raise the rolling shutter until it reaches an intermediate opening of the slats
(preferred opening position);
• Perform the following confirmation sequence:
The rolling shutter will move in sequence to the memorised positions: closed, maximum
opening, preferred opening.
Functions of the button panel*
Type of Command
Outside of tilting area
In tilting area
UP short
Completely raised
Less light
DOWN short
Completely lowered
More light
UP long
Entry in tilting area
Out of tilting area
Completely raised
DOWN long
Entry in tilting area
Out of tilting area
Completely lowered
sequence DOWN/UP
(0.5 sec)
Entry in tilting area
-
sequence UP/DOWN
(0.5 sec)
Entry in tilting area
-
* see key to symbols and operational notes
SLAT TILTING MECHANISM SETTING
MODE 2
:
Orientable roller shutter without coupling point with tilting
function adjustable below the lower limit.
Only for roller shutter type Solomatic.
Not suitable for centralised control units. Not available on motors Ø 35.
E N G L I S H
PROGR.
FROM THE WHITE WIRE