65
NOTES FOR THE CONTEMPORANEOUS USE OF THE MIDDLE POSITION
AND THE TILTING / ORIENTATION FUNCTIONS
In the sections above, situations were discussed in which either only the tilting /
orientation function or only the middle position function were to be used. If only one of
the functions has been programmed the commands for its use are the same (long B from
the UP/DOWN on the remote control, or UP/DOWN on the button panel).
When both tilting / orientation functions and the middle position functions have been
programmed, the commands for using them change as follows:
- Reaching the middle position: use long-B (2 seconds) on the remote control.
- Entering tilting / orientation mode: on the remote control type SKIPPER press A+C,
while on remote control type GIRO execute the sequence STOP short (<2s) + STOP
long (2s).
ONLY MODE 1-2-3
MOVEMENT TO THE FIRST MIDDLE POSITION:
Execute the sequence UP short (< 0,5 s) - DOWN short (< 0,5 s).
ENTRY IN TILTING AREA / OPENING SLATS:
Execute the sequence UP short (< 0,5 s) - DOWN long (> 1 s).
UP
DOWN
UP
DOWN
press briefly
< 0.5 sec
press briefly
< 0.5 sec
press briefly
press and hold
release
release
release
release
< 0.5 sec
> 1 sec
< 0.5 sec
.....
< 0.5 sec
.....
E N G L I S H
REMO
TE CONTROL PROGR.