1224 East Warner Ave,
Santa Ana, CA 92705
Tel: 1-714-850-6022
www.cherryaerospace.com
H83B-6MBU
MAXIBOLT STRAIGHT PULLING HEAD,
FOR -6 DIAMETER “U” TYPE MAXIBOLT
®
FASTENERS
Technical Data Sheet
, Page 1 of 2
A
TS-H83B-6MBU Rev: C Date: 08/16/17 CR: 17-0658
DIMENSIONAL DATA
(all measurements in Inches, see figure 1)
Pulling Head Weight: 0.2 Lbs (0.09 kg)
CHOICE OF RIVETERS
•
G83A
and G84 P
ower Riveter
s
•
G84-LS Split Power Riveter (with adaptor 744-700)
MOUNTING INSTRUCTIONS
•
Attach riveter to air source for correct piston positioning.
•
Thread Collet Assembly securely onto the riveter head piston.
•
Depress the trigger and attach the sleeve assembly onto the bayonet mount.
USAGE
•
Use for
-6 diameter
Cherry
“U” type Maxibolt® and Huck™
(ALCOA) “U” and
“S”
T
ype Blind Bolts.
BEFORE USE, MAKE SURE THAT:
•
Proper air source is connected (see riveter
manual
for recommended pressure).
•
Inspect the front end of the nosepiece to make
sure that
it
is clean and in good working condition
DURING OPERATION
•
Visually inspect
the active area of the nose piece regularly.
•
Keep the nose piece and jaws
clean, especially
when sealants are used.
•
If stem slippage occurs,
clean or replace
the
internal
jaws.
Figure 1
