Procedure
Quantum Smart-1 6000-L/6000-XL Appliances Replacing Memory | 12
Procedure
Memory Kit Contents
n
Installation guide -
Smart-1 Installing and Removing Memory
n
Expansion DIMMs
n
Electrostatic Discharge (ESD) grounding wrist strap (anti-static)
To install a new DIMM:
1.
Prepare the appliance.
2.
Remove the cooling air shroud.
3.
Remove a DIMM (if necessary).
4.
Install a DIMM.
5.
Install the cooling air shroud.
6.
Reassemble the appliance.
7.
Verify the memory configuration.
Preparing the Appliance
To prepare the appliance:
1.
Make sure to follow the
"Safety Instructions" on page 5
2.
Shut down the appliance:
n
In Gaia Portal:
Go to
Maintenance
>
Shut Down
, and click
Halt
n
In Gaia Clish:
Run:
halt
3.
Open the retention strap that secures the power cables to the PSUs.
4.
If AC PSUs are installed in the appliance:
Disconnect the power cables from the AC PSUs.
5.
If DC PSUs are installed in the appliance:
Disconnect the safety ground wires from the DC PSUs.
Disconnect the DC power connectors from the DC PSUs.
6.
Remove the hook-and-loop straps that hold and secure the system cables, if they interfere with the
PSU removal.
