31
7.
ME MOR Y R E AD (MR )
7.1 OBJECT
The
MR
position (
Memory Read
, display of stored data) is used to display
measurements previously stored by pressing the
MEM
key.
7.2 SELECTION OF THE
MEMORY READ
MODE
Set the function switch to
MR
. The choice of mode (
Standard
or
Advanced
) was
made by parameterizing; see §8.5, menu 9.
7.3 DATA DISPLAYED
This depends on which mode is active,
Standard
or
Advanced
, independently of
the mode in which the records were made.
7.3.1
DATA DISPLAYED IN
STANDARD
MODE
The last measurement is displayed.
The
MR
memory read symbol and
the sequence number of the record
being read are also displayed.
The figure opposite illustrates an
impedance + current measurement
(
Ω+A
setting).
Fig. 25
The stored values are displayed as
they were when recorded, namely,
same display range, alarm states,
NOISE
signal, battery condition,
etc.
However, the audible alarms are
not reproduced; only the
AL
icon
and the alarm threshold blink.
The figure opposite illustrates a
current measurement (
A
setting).
Fig. 26
