Swarm
™ User Manual
7
4/23/2009 11:59 AM
The fuse is located
inside this
compartment.
Remove using a flat
head screwdriver.
3.
S
ETUP
Fuse Replacement
1.
With a flat head screwdriver, wedge the
fuse holder out of its housing.
2.
Remove the damaged fuse from its holder
and replace with exact same type fuse.
3.
Insert the fuse holder back in its place and reconnect power.
Fixture Linking
You will need a serial data link to run light shows of one or more fixtures using a DMX-512 controller
or to run synchronized shows on two or more fixtures set to a master/slave operating mode. The
combined number of channels required by all the fixtures on a serial data link determines the number
of fixtures the data link can support.
Important:
Fixtures on a serial data link must be daisy chained in one single line. To comply with the EIA-
485 standard no more than 32 devices should be connected on one data link. Connecting more
than 32 fixtures on one serial data link without the use of a DMX optically-isolated splitter may
result in deterioration of the digital DMX signal.
Maximum recommended serial data link distance: 500 meters (1640 ft.)
Maximum recommended number of fixtures on a serial data link: 32 fixtures
Disconnect the power cord before replacing a fuse and always
replace with the same type fuse.
