DIAMONDstrip™ Mini User Manual
12
1/26/2010 2:58 PM
Master/Slave & Stand Alone
The Master/Slave mode will allow you to link units in a daisy chain fashion. In this mode, the first unit
in the daisy chain will command all other units following. Stand Alone can simply be achieved by
setting all units to Master. They would no longer be required to be linked in series.
Built in programs detailed
P
ROGRAM
F
UNCTION
O
PTIONS
000
Blackout
001-007
Solid flashing white
F
= Flash speed
008-013
Chase programs
P
=
Run speed
F
= Flash speed
014-020
Sequential chase patterns
Use sound sensitivity rotary knob to adjust sound
level for optimum response or decrease sensitivity
completely to operate in Run speed only
P
=
Run speed
021
White zones (manual dimming)
P
= Zone 1
F
=
Zone 2
C
=
Zone 3
022
White fade
P
= Run speed
MASTER UNIT Settings
Press the
Mode
button. Then, by using the
Up
/
Down
buttons, select [
], then press the
Enter
button.
Select programs
by using the
Up
/
Down
buttons. Press the
Enter
button.
Some programs
have additional controls such as flash
and run speed. Press the
Mode
button to toggle
additional functions, then use the
Up/Down
buttons to change values.
Refer to the Control Panel Modes & Functions
chart on the
previous page.
Master
Slave
Slave
IMPORTANT INSTRUCTIONS FOR MASTER/SLAVE OPERATION
Turn
ON
the Master unit
last
! This will assure that the master unit will fully detect all linked units, and re-configure its
built-in sequential chase programs to run on the correct number of linked units.
SLAVE UNIT Settings
Units that follow the Master unit
will automatically synchronize to
the
Master unit. No other
settings are required.
Master/Slave Link
output
3 Pin XLR DMX
cable
Slave
DMX signal output
does not continue
on M/S linked
fixtures.
