Page 7 of 15
S
ETUP
AmHaze Stadium User Manual Rev. 1
4. S
ETUP
AC Power
Each AmHaze Stadium has a fixed power supply that works with an input voltage of either 120 VAC, 60 Hz
or 230 VAC, 50 Hz, depending on the specific model. To determine the power requirements for each
AmHaze Stadium, refer to the label affixed to the product. You can also refer to the Technical
Specifications chart in this manual.
The listed current rating indicates the maximum current draw during normal operation. For more
information, download Sizing Circuit Breakers from the Chauvet website:
www.chauvetprofessional.com
.
.
AC Plug
The AmHaze Stadium comes with a power input cord terminated with a Seetronic Powerkon IP65
connector on one end and an Edison plug on the other end (U.S. market). If the power input cord that
came with your product has no plug, or if you need the change the plug, use the table below to wire the
new plug.
Resetting the Breaker
This product is equipped with a resettable circuit breaker. If the breaker trips, all sections of this product will
lose power.
1.
Remove the power cord from mains power.
2.
Allow unit to cool for 15 minutes.
3.
After 15 minutes, you may attempt to reset the breaker by pressing the button with your finger.
4.
Plug the product’s power cord into the power outlet and continue using as recommended.
DMX Linking
You can link the AmHaze Stadium to a DMX controller using a 3- or 5-pin DMX connection. If using other
DMX-compatible products with this product, you can control each individually with a single DMX controller.
DMX Personalities
The AmHaze Stadium uses a 3- or 5-pin DMX data connection for the 2-channel DMX personality.
•
Refer to the Introduction for a brief description of each DMX personality.
•
Refer to the Operation chapter to learn how to configure the AmHaze Stadium to work in these
personalities.
•
The DMX Values section provides detailed information regarding the DMX personalities.
•
Always connect the product to a protected circuit (circuit breaker or fuse). Make
sure the product has an appropriate electrical ground to avoid the risk of
electrocution or fire.
•
To eliminate unnecessary wear and improve its lifespan, during periods of non-
use completely disconnect the product from power via breaker or by unplugging
it.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if
the rheostat or dimmer channel serves only as a 0 to 100% switch.
Connection
Wire (U.S.)
Wire (Europe)
Screw Color
AC Live
Black
Brown
Yellow or Brass
AC Neutral
White
Blue
Silver
AC Ground
Green/Yellow
Green/Yellow
Green
If you are not familiar with or need more information about DMX standards,
Master/Slave connectivity, or the DMX cables needed to link this product to a
DMX controller, download the DMX Primer from the Chauvet website:
www.chauvetprofessional.com
.
!
