Page 16 of 33
Joining Each F2 (Creating a Modular Design)
F2 User Manual Rev. 1
Vertical Panel Connection
Use the following instructions to join panels vertically:
1.
Line up the alignment conicals at the top of each panel, and the alignment magnets at the top and
bottom of each panel.
2.
Push male Speego connections into female Speego connections.
3.
Turn the spring knobs clockwise until secure.
4.
Turn the tightening latches counter-clockwise until secure.
Due to tolerances in the materials, as well as wear and tear of the latches, some tightening
latches may not line up when tightened. This is normal.
Warning! The magnetic attachments are not load-bearing, and are intended for alignment
assistance only. Do not release panel until the hanging hardware has been fully secured.
Summary of Contents for F2
Page 1: ...User Manual ...