Page 13 of 33
F2 User Manual Rev. 1
Mounting
Flat Wall Installation
Refer to the following diagrams for flat wall installation.
The 4 rear and front mounting holes are intended for flush mount installation to a flat
surface against the video panels. 1 mounting point for every junction, including outside
edges and corners, must be used in order to maintain structural integrity. The mounting
points are not intended for hanging or suspending from a truss or other overhead
structure.
The 2 rear mounting holes in the middle of the product are intended for use with the
Ground Support 2 Kit from Chauvet.
Spacers greater than 5 mm thick must be used at each mounting point, between the panels
and the struts.
Chauvet recommends using a VERTICAL steel strut for each column of panels, plus 1, as
in the following diagram:
The illustrations above are examples only. Please refer to all applicable local codes and
regulations for the proper installation of the product.
Mounting Points on a Flat Wall
Rear
Threaded Mounting Holes
Size M12 (x6)
Front
Mounting Holes
Size M10 (x6)
At least 1 mounting point for
every junction (circled above)
must be secured, including
outside edges and corners
M12 bolts must be
used for rear mounting
applications
SAE 3/8” or M10 bolts
are compatible for front
mounting applications
4 c 1
= 5 steel struts
Summary of Contents for F2
Page 1: ...User Manual ...